{
  "number": 4332,
  "title": "Cisco's Mobile IPv4 Host Configuration Extensions",
  "authors": [
    "K. Leung",
    "A. Patel",
    "G. Tsirtsis",
    "E. Klovning"
  ],
  "published": "2005-12",
  "status": "Informational",
  "stream": "INDEPENDENT",
  "pages": 11,
  "formats": [
    "TXT",
    "HTML"
  ],
  "abstract": "An IP device requires basic host configuration to be able to communicate. For example, it will typically require an IP address and the address of a DNS server. This information is configured statically or obtained dynamically using Dynamic Host Configuration Protocol (DHCP) or Point-to-Point Protocol/IP Control Protocol (PPP/IPCP). However, both DHCP and PPP/IPCP provide host configuration based on the access network. In Mobile IPv4, the registration process boots up a Mobile Node at an access network, also known as a foreign network. The information to configure the host needs to be based on the home network. This document describes the Cisco vendor-specific extensions to Mobile IPv4 to provide the base host configuration in Registration Request and Reply messages. This memo provides information for the Internet community.",
  "keywords": [
    "dynamic host configuration protocol",
    "dhcp",
    "point-to-point",
    "ip control protocol",
    "ppp",
    "ipcp"
  ],
  "draft": "draft-leung-cisco-mip4-host-config-04",
  "doi": "10.17487/RFC4332",
  "urls": {
    "html": "https://rfc.dk/rfc4332/",
    "text": "https://rfc.dk/rfc4332.txt",
    "rfc_editor": "https://www.rfc-editor.org/rfc/rfc4332",
    "datatracker": "https://datatracker.ietf.org/doc/rfc4332/"
  },
  "text_modified": "2005-12-20T00:50:41Z"
}